Snap-on Motorized Loader Manual de usuario descargar pdf (Pagina 77)

6-5

2000-800-02 Motorized Loader

The connector on single transducer cables contains

the EEPROM calibration memory chip. Never

attempt to remove the connector from the

transducer.

D — Linear Bearings

May be slipped over the reaction pins to reduce friction when

testing very small or high resolution electronic wrenches.

E — Reaction Pins

Hold the reaction block in place.

F — Reaction Block

The reaction block is positioned so that the reaction pins

straddle the wrench handle at the hand hold position specified

on the wrench.

G — Motorized Control Box

Control motor speeds, Run, Stop, Cycling up to 99,999 times.

H — Hand Crank

Turn hand crank on the loader to apply torque. 2000 ft lbs of

torque are generated with only 10 ft lbs of manual torque

applied.

Adjustable stops on the reaction pins may be raised

or lowered to level the wrench prior to loading. Do

not place a second stop above the wrench handle. It

is normal for the wrench handle to rise as it levels

itself under load.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 101 102

Sin comentarios

Snap-on Motorized Loader Manual de usuario Pagina 77