Snap-on Motorized Loader Manual de usuario descargar pdf (Pagina 79)

6-7

2000-800-02 Motorized Loader

4-in-1 Transducer (Accessory)

The 4-in-1 transducer is mounted to the loader using the

standoff fixture and bracket assembly as shown in Figure 6-4.

Figure 6-4: 4-in-1 Transducer on 2000-800-02 Motorized Loader

A — Quick Release Pins

Four quick release pins must be installed. The first two secure

the standoff fixture to the loader and the second two lock the

adaptor to the transducer bracket.

B — Loader Standoff (under bracket)

The standoff and bracket must be installed into the loader by

lining up the holes of the standoff to the holes of the loader.

C & D — Bracket Knobs

Two knobs on the bracket are used to align the selected

transducer over the loader drive. Tighten the left knob (D) first,

then the top knob (C). The wrench or driver to be tested is then

coupled to the selected transducer using an internal-internal

adaptor.

E — 4-in-1 Adapter Bracket

Holds the 4-in-1 transducer horizontal to the loader.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 101 102

Sin comentarios

Snap-on Motorized Loader Manual de usuario Pagina 79